H13L-1742
Uncertainty Analysis of non-point source pollution control facilities design techniques in Korea

Monday, 14 December 2015
Poster Hall (Moscone South)
Lee Okjeong, Jeonghoon Lee, Choe bo Gyeong, Myung woo Park and Sangdan Kim, Pukyong National University, Busan, South Korea
Abstract:
The design of non-point sources control facilities in Korea is divided largely by the stormwater capture ratio, the stormwater load capture ratio, and the pollutant reduction efficiency of the facility. The stormwater capture ratio is given by a design formula as a function of the water quality treatment capacity, the greater the capacity, the more the amount of stormwater intercepted by the facility. The stormwater load capture ratio is defined as the ratio of the load entering the facility of the total pollutant load generated in the target catchment, and is given as a design formula represented by a function of the stormwater capture ratio.

In order to estimate the stormwater capture ratio and load capture ratio, a lot of quantitative analysis of hydrologic processes acted in pollutant emission is required, but these formulas have been applied without any verification. Since systematic monitoring programs were insufficient, verification of these formulas was fundamentally impossible. However, recently the Korean ministry of Environment has conducted an long-term systematic monitoring project, and thus the verification of the formulas became possible.

In this presentation, the stormwater capture ratio and load capture ratio are re-estimated using actual TP data obtained from long-term monitoring program at Noksan industrial complex located in Busan, Korea. Through the re-estimated process, the uncertainty included in the design process that has been applied until now will be shown in a quantitative extent. In addition, each uncertainty included in the stormwater capture ratio estimation and in the stormwater load capture ratio estimation will be expressed to quantify the relative impact on the overall non-point pollutant control facilities design process. Finally, the SWMM-Matlab interlocking module for model parameters estimation will be introduced.

Acknowledgement

This subject is supported by Korea Ministry of Environment as "The Eco Innovation Project : Non-point source pollution control research group“