MR33B-2662
Magnetic properties of cores from the Wenchuan Earthquake Fault Scientific Drilling Hole-2 (WFSD-2), China
Wednesday, 16 December 2015
Poster Hall (Moscone South)
LEI Zhang Jr1,2, Zhiming Sun3, Haibing Li4, Yong Cao1,5, Xiaozhou Ye1, Leizhen Wang2,6, Yue Zhao3 and Shuai Han4, (1)Institute of Geomechanics, Chinese Academy of Geological Sciences, Beijing, China, (2)China University of Geosciences Wuhan, Wuhan, China, (3)CAGS Chinese Academy of Geological Sciences, Beijing, China, (4)Institute of Geology, CAGS, Beijing, China, (5)China University of Geosciences Beijing, Beijing, China, (6)Jiangsu Branch of China Geological Exploration Center of Building Materials Industry, Nanjing, China
Abstract:
During an earthquake, seismic slip and frictional heating may cause the physical and chemical alterations of magnetic minerals within the fault zone. Rock magnetism provides a method for understanding earthquake dynamics. The Wenchuan earthquake Fault Scientific Drilling Project (WFSD) started right after 2008 Mw7.9 Wenchuan earthquake, to investigate the earthquake faulting mechanism. Hole 2 (WFSD-2) is located in the Pengguan Complex in the Bajiaomiao village (Dujiangyan, Sichuan), and reached the Yingxiu-Beichuan fault (YBF). We measured the surface magnetic susceptibility of the cores in WFSD-2 from 500 m to 1530 m with an interval of 1 cm. Rocks at 500-599.31 m-depth and 1211.49-1530 m-depth are from the Neoproterozoic Pengguang Complex while the section from 599.31 m to 1211.49 m is composed of Late Triassic sediments. The magnetic susceptibility values of the first part of the Pengguan Complex range from 1 to 25 × 10-6 SI, while the second part ranges from 10 to 200 × 10-6 SI, which indicate that the two parts are not from the same rock units. The Late Triassic sedimentary rocks have a low magnetic susceptibility values, ranging from -5 to 20 × 10-6 SI. Most fault zones coincide with the high value of magnetic susceptibility in the WFSD-2 cores. Fault rocks, mainly fault breccia, cataclasite, gouge and pseudotachylite within the WFSD-2 cores, and mostly display a significantly higher magnetic susceptibility than host rocks (5:1 to 20:1). In particular, in the YBF zone of the WFSD-2 cores (from 600 to 960 m), dozens of stages with high values of magnetic susceptibility have been observed. The multi-layered fault rocks with high magnetic susceptibility values might indicate that the YBF is a long-term active fault. The magnetic susceptibility values change with different types of fault rocks. The gouge and pseudotachylite have higher values of magnetic susceptibility than other fault rocks. Other primary rock magnetism analyses were then performed to investigate the mechanisms. We consider that the principal mechanism for the high magnetic susceptibility of these fault rocks is most likely the production of new magnetite from iron-bearing paramagnetic minerals (such as silicates or clays). These new magnetites might originate from frictional heating on a seismic fault slip plane or seismic fluid during an earthquake.
