G21A-1010
InSAR Analysis of the 2011 Hawthorne (Nevada) Earthquake Swarm: Implications of Earthquake Migration and Stress Transfer
Tuesday, 15 December 2015
Poster Hall (Moscone South)
Xianjie Zha, University of Science and Technology of China, Hefei, China, Zhiyang Dai, USTC University of Science and Technology of China, Hefei, China and Zhong Lu, Southern Methodist University, Dallas, TX, United States
Abstract:
The 2011 Hawthorne earthquake swarm occurred in the central Walker Lane zone, neighboring the border between California and Nevada. The swarm included an Mw 4.4 on April 13, Mw 4.6 on April 17, and Mw 3.9 on April 27. Due to the lack of the near-field seismic instrument, it is difficult to get the accurate source information from the seismic data for these moderate-magnitude events. ENVISAT InSAR observations captured the deformation mainly caused by three events during the 2011 Hawthorne earthquake swarm. The surface traces of three seismogenic sources could be identified according to the local topography and interferogram phase discontinuities. The epicenters could be determined using the interferograms and the relocated earthquake distribution. An apparent earthquake migration is revealed by InSAR observations and the earthquake distribution. Analysis and modeling of InSAR data show that three moderate magnitude earthquakes were produced by slip on three previously unrecognized faults in the central Walker Lane. Two seismogenic sources are northwest striking, right-lateral strike-slip faults with some thrust-slip components, and the other source is a northeast striking, thrust-slip fault with some strike-slip components. The former two faults are roughly parallel to each other, and almost perpendicular to the latter one. This special spatial correlation between three seismogenic faults and nature of seismogenic faults suggest the central Walker Lane has been undergoing southeast-northwest horizontal compressive deformation, consistent with the region crustal movement revealed by GPS measurement. The Coulomb failure stresses on the fault planes were calculated using the preferred slip model and the Coulomb 3.4 software package. For the Mw4.6 earthquake, the Coulomb stress change caused by the Mw4.4 event increased by ~0.1 bar. For the Mw3.9 event, the Coulomb stress change caused by the Mw4.6 earthquake increased by ~1.0 bar. This indicates that the preceding earthquake may trigger the subsequence one. Because no abnormal volcano activity was observed during the 2011 Hawthorne earthquake swarm, we can rule out the volcano activity to induce these events. However, the groundwater change and mining in the epicentral zone may contribute to the 2011 Hawthorne earthquake.