Detecting elevation changes over mountain glaciers in Tibet and the Himalayas by TOPEX/Poseidon and Jason-2 radar altimeters: comparison with ICESat results

Abstract:

In most cases, mountain glaciers are narrow and situated over steep slopes. A laser-based altimeter such as ICESat has a small illuminated footprint at about 70 m, thus allowing to measure precise elevations over narrow mountain glaciers. However, unlike a typical radar altimeter mission, ICESat does not have repeat ground tracks (except in its early phase) to measure heights of a specific point at different times. Within a time span, usually a reference digital elevation model is used to compute height anomalies at ICESat’s measurement sites over a designated area, which are then averaged to produce a representative height change (anomaly) in this area. In contrast, a radar altimeter such as TOPEX/Poseidon (TP; its follow-on missions are Jason-1 and -2), repeats its ground tracks at an even time interval (10 days for TP), but has a larger illuminated footprint than ICESat’s (about 1 km or larger), making it difficult to measure precise elevations over narrow mountain glaciers. Here we demonstrate the potential of TP and Jason-2 radar altimeters in detecting elevation changes over mountain glaciers that are sufficiently wide and smooth. We select several glacier-covered sites in Mt. Tanggula (Tibet) and the Himalayas to experiment with methods that can generate precise height measurements from the two altimeters. Over the same spot, ranging errors due to slope, volume scattering and radar penetration can be common between repeat cycles, and may be reduced by differencing successive heights. We retracked radar waveforms and classify the surfaces using the SRTM-derived elevations. The effects of terrain and slope are reduced by fitting a surface to the height measurements from repeat cycles. We remove outlier heights and apply a smoothing filter to form final time series of glacier elevation change at the selected sites, which are compared with the results from ICESat (note the different mission times). Because TP and Jason-2 measure height changes every 10 days, clear annual and inter-annual oscillations of glacier heights are present in the resulting time series, in comparison to the unevenly sampled height changes from ICESat that do not show such oscillations. The rates of glacier elevation change from T/P and Jason-2 are mostly negative, but vary with locations and heights.