ED33D-0972
Locating Local Earthquakes Using Single 3-Component Broadband Seismological Data

Wednesday, 16 December 2015
Poster Hall (Moscone South)
Srijan Bharati Das, Indian Institute of Science Education and Research Kolkata, Kolkata, India, Supriyo Mitra, Indian Institute of Science Education and Research Kolkata, Earth Sciences, Kolkata, India and The Single Station Earthquake Locating Team
Abstract:
We devised a technique to locate local earthquakes using single 3-component broadband seismograph and analyze the factors governing the accuracy of our result. The need for devising such a technique arises in regions of sparse seismic network. In state-of-the-art location algorithms, a minimum of three station recordings are required for obtaining well resolved locations. However, the problem arises when an event is recorded by less than three stations. This may be because of the following reasons: (a) down time of stations in a sparse network; (b) geographically isolated regions with limited logistic support to setup large network; (c) regions of insufficient economy for financing multi-station network and (d) poor signal-to-noise ratio for smaller events at most stations, except the one in its closest vicinity. Our technique provides a workable solution to the above problematic scenarios. However, our methodology is strongly dependent on the velocity model of the region. Our method uses a three step processing: (a) ascertain the back-azimuth of the event from the P-wave particle motion recorded on the horizontal components; (b) estimate the hypocentral distance using the S-P time; and (c) ascertain the emergent angle from the vertical and radial components. Once this is obtained, one can ray-trace through the 1-D velocity model to estimate the hypocentral location. We test our method on synthetic data, which produces results with 99% precision. With observed data, the accuracy of our results are very encouraging. The precision of our results depend on the signal-to-noise ratio (SNR) and choice of the right band-pass filter to isolate the P-wave signal. We used our method on minor aftershocks (3 < mb < 4) of the 2011 Sikkim earthquake using data from the Sikkim Himalayan network. Location of these events highlight the transverse strike-slip structure within the Indian plate, which was observed from source mechanism study of the mainshock and larger aftershocks.