Three-dimensional Magnetotelluric Modeling of the Pohukuloa Training Area, Hawaii Island

Abstract:

We report the results of 3D modeling of magnetotelluric (MT) data collected in the Pohakuloa Training Area (PTA) on the saddle between Mauna Loa and Mauna Kea volcanoes on Hawaii Island. We have previously used lower frequency MT data to construct 1D and 2D resistivity profiles in this area and confirmed the presence of a low-resistivity region at depths of about 2 km. One of our drill holes in PTA had previously encountered temperatures of 150 C at a similar depth. However, our 1D and 2D models were unable to fit features of the data that we suspected were due to 3D variations in subsurface resistivity. For the 3D modeling, we reprocessed the higher frequency data (1 kHz sampling rate) which were available at all 20 sites. We were then able to obtain complex impedances at frequencies of 0.5-500 Hz to use for the 3D inversion. We used Siripunvaraporn's 3D inversion method to obtain resistivities in a rectangular array of 0.5x0.5x0.25 km blocks spanning the areal extent of the stations down to a depth of 2.5 km. The results confirmed that much of the anomalous data could be explained by near-surface 3D variations in resistivity. The underlying conductor of 5-10 ohm-m at 2 km depth now appears to extend over the entire survey area.